Protektive Pak is introducing new Statshield® Metal-In ESD shielding bags. These bars have low-charging interior and exterior layers. Inherent static dissipative properties will not wear off, and are not humidity dependent. Thermo transfer printing will not flake off or particulate, thereby reducing cross-contamination. Proprietary film has very low NVR and ionics. Independent lab chemical analysis is available. 40% light transmission allows for easy identification of bag contents. Meets MIL-PRF-81705D Type III. ANSI/ESD S541 6.2 states that “Transportation of sensitive products outside of an EPA (ESD Protected Area) shall require packaging that provides: 1. Low charge generation; 2. Dissipative or conductive materials for intimate contact; 3. A structure that provides electrostatic discharge shielding.” Statshield® Metal-In ESD shielding bags meet this requirement. Ten standard sizes to cover most applications are available in both zipper and non-zipper. • Surface Resistance: • Outer Surface <10E11 ohms • Aluminum Layer <10E2 ohms • Inner Surface <10E11 ohms • Static Shielding <25 nJ • Charge Generation Teflon: 0.09 nC/sq. in. Quartz: 0.01 nC/sq. in • Bag Thickness: Thickness Nominal .0030” (.0762mm) ±10% • Width (Inside Dimensions) Nominal -0” / + .125” • Length (Inside Dimensions) Nominal ± .125” • Light Transmission (%) >40% (Tobias) • Burst Strength (psi) >50 • Heat Seal (lbs/in) >10 • Seam Strength Pass • Tear Strength (lbs) >25 • Puncture Resistance (lbs) >10 • MVTR (gms / 100 in2 • / 24 hrs, 100°F) <0.40 • OTR (cc / 100 in2 • / 24 hrs) <6.1 • Abrasion Resistance >100 cycles • Outgassing Pass • Non-corrosive Pass.
