FEV100 Electric Vehicle Charging Station Test Adapter

2022 NED Innovation Award Winner

---

The FEV100 Electric Vehicle Charging Station Test Adapter tests the safety and performance of level 1 or level 2 electric vehicle AC charging stations (EVSEs) with type 1 connectors.

 

One of the challenges of testing EVSEs is that they traditionally have required an electric vehicle (EV) to be connected before it will fully operate—which means every technician must drive an EV to perform certain tests. The adapter simulates the presence of an EV, allowing technicians to test the charging station in combination with appropriate test instruments, such as digital multimeters and ScopeMeters.

 

Compliant with the SAE J1772 standards for North American charging stations, the adapter allows a technician to verify that after installation, a charger can communicate and deliver power to vehicles. The FEV100 Kit includes the Fluke FEV100/BASIC Test Adapter, FEV-COM/TY1 Type 1 Connector and Cable, and a soft carrying case.

• Check protective earth for correct wiring and functioning with the PE pre-test feature. 
• Perform GFCI troubleshooting of EVSE and verify operation within safety standards. 
• Test charging states of EVSE with CP state simulation. 
• Verify charging voltage and maximum available current using a multimeter.
• SAE J1772 compliant to North American standards.

General SpecificationsInput VoltageUL1/N, UL2/N = 120V, UL1/L2 = 208V, 60 Hz (three-phase)
or
UL1/N, UL2/N = 120V, UL1/L2 = 240V,
60 Hz (single-phase),
±10% voltage fluctuations from nominalEV Connector (EVC-13)SAE J1772 socket, 16 A (type 1, 5P single-phase)Internal Power Consumption2 W max.Operating Temp.-4 to 104°F (-20 to 40°C)Storage Temp.-4 to 122°F (-20 to 50°C)Operating Humidity Range10 to 85% relative humidity non-condensingStorage Relative Humidity0 to 85 % non-condensingOperating Altitude6,561 ft (2,000 m) max.Dimensions (H × W × D)Approx. 8.66 x 4.33 x 1.77 in. (220 x 110 × 45 mm)WeightApprox. 4.4 lb. (2 kg)Safety StandardsIEC 61010-1, Pollution Degree 2
IEC 61010-2-030Measurement CategoryCAT II 250VIP Protection ClassIP54Electromagnetic Compatibility (EMC)InternationalIEC 61326-1: Basic Electromagnetic Environment
CISPR 11: Group 1, Class AUSA (FCC)47 CFR 15 subpart B.FunctionsCP StatesA, B, C, DCP Error “E”On/offPE ErrorOn/offGFCI TestYes, test resistor of 2 k? connected between L1 and PE,
time limitation 40 msPE Pre-Test (typical)Visible indication >30V on PE conductorOutputsMeasuring Terminals
L1, L2/N, PEMax. 250V 50/60 Hz, CAT II 250VCP Signal Output TerminalsApprox. ±12V (under normal conditions),
in case of wrong wiring or error of the charging station
these terminals can be hazardous ? max. 250V against PE